I am trying to get my setup working to get on a BBS, and having no luck(little over my head and need help)
Here is my setup
Stock 800XL, atari 850 with CX87 cable in port R1, 25 pin to the UDS-10. Ethernet cable from the UDS-10 to a Xfinity modem/router
BobTerm 1.22 set to full duplex, ASCII, 9600
Here is my UDS-10 config.
*** basic parameters
Hardware: Ethernet Autodetect
IP addr - 0.0.0.0/DHCP/BOOTP/AutoIP, gateway 10.0.0.1,netmask 255.255.255.0
DHCP device name : not set
*** Security
SNMP is enabled
SNMP Community Name: public
Telnet Setup is enabled
TFTP Download is enabled
Port 77FEh is enabled
Web Server is enabled
ECHO is disabled
Enhanced Password is disabled
*** Channel 1
Baudrate 9600, I/F Mode 4C, Flow 00
Port 10001
Connect Mode : D6
Auto increment source port disabled
Remote IP Adr: --- none ---, Port 10001
Disconn Mode : 80
Flush Mode : 00
*** Expert
TCP Keepalive : disabled
ARP cache timeout: 600s
Monitor Mode @ bootup : enabled
HTTP Port Number : 80
I have the UDS-10 set to DHCP in the router, I can ping it fine from my PC, and I can access the device installer from my PC.
When I load bobterm 1.22, I get the load 2sec beep for the 850 driver, but then I have just a constant high pitch beep that changes pitch depending on the baud rate
When I try to "dial" out in terminal mode, I get a "NO CARRIER"
I am kinda stuck at this point so any help would be great!
Thanx
Doug NJ
