So last year at MGC this unit was working fine. I pulled it out of (dry, semi-sealed) storage today to inventory everything and found this:
![Posted Image]()
No way I can slip a composite cable over that. What would have caused that kind of damage? It's like the edge connector just bubbled up or something...it almost looks burned. Should I just try to Dremel it back down? Try to "desolder" it?
[edit] Upon further review, I think I picked this unit up afterwards. It's looks as though the connectors have been soldered. Should I just desolder whatever's on there?
![Posted Image]()
![Posted Image]()
No way I can slip a composite cable over that. What would have caused that kind of damage? It's like the edge connector just bubbled up or something...it almost looks burned. Should I just try to Dremel it back down? Try to "desolder" it?
[edit] Upon further review, I think I picked this unit up afterwards. It's looks as though the connectors have been soldered. Should I just desolder whatever's on there?
