Got my UltraSatan a while back but just broke it out to start using to make backups of my HDD's. It was working fine.Connected it and ran the config to set the drive ID's to 2-3 to work with a MegaSTe I want to back up. No issues. Then I did a search for updates to the US and found the 1.13 firmware update, so I downloaded and installed the new firmware. Now the US will not respond to anything. I get a power light but when I insert a card, no flash from the drive lights. I have taken it out of its case and jumped the base firmware jumper but no change. If fact, now when I connect it to the computer, my floppy drive starts getting read errors when trying to access a disk. Half the time, with it connected, the ST will just start to the desktop with no drive activity. HELP!!!
The US I have is Jookie's version, black case with the card slots up/down from each other. As I said, this is the first I've started using it as it's been sitting on my Atari desk since I bought it.
↧
HELP! UltraSatan Bricked!
↧