Hi,
Forgive me if this has already been discussed in other threads, but I couldn't find anything after searching...
Has anyone successfully used a 7800 proline controller guts to make a custom arcade stick using arcade quality cherry switch buttons and joysticks? My main concern is if it will work by simply tapping right into the wires without disconnecting them from the board/resisters. I wasn't even planning to solder anything but just crimp the new joystick harness to the apprpriate wires on the proline guts, and daisy chain any grounds if applicable. What do you guys think?
Forgive me if this has already been discussed in other threads, but I couldn't find anything after searching...
Has anyone successfully used a 7800 proline controller guts to make a custom arcade stick using arcade quality cherry switch buttons and joysticks? My main concern is if it will work by simply tapping right into the wires without disconnecting them from the board/resisters. I wasn't even planning to solder anything but just crimp the new joystick harness to the apprpriate wires on the proline guts, and daisy chain any grounds if applicable. What do you guys think?