Hi - can someone help me on a few loose ends with this nice product!
Im trying to load DOS 2.5 from an ATR file on the pc formated CF card (fat 32). however, after loading - i cant switch over to the 1050 disk drive to format/read contents etc - as it uses the CF card as the primary source of data (and cant see the drive)
Is it possible to switch SIDE hardware off whilst the machine is running without going into the menu? (or switch to the 1050)
Going into the menu and switching it off then results in the data being lost.
(please avoid SDX solutions unless unavoidable, a pure hardware switch is ideal to keep it simple).
Also -
What does changing the SIDE PBI ID achieve?
Why would you care about joysticks 3 & 4 being off or not?
sorry if this is covered somewhere, but ive searched endlessly and i dont think its been covered as yet, where the Ultimate 1mb has more Q&A.
Rich
Im trying to load DOS 2.5 from an ATR file on the pc formated CF card (fat 32). however, after loading - i cant switch over to the 1050 disk drive to format/read contents etc - as it uses the CF card as the primary source of data (and cant see the drive)
Is it possible to switch SIDE hardware off whilst the machine is running without going into the menu? (or switch to the 1050)
Going into the menu and switching it off then results in the data being lost.
(please avoid SDX solutions unless unavoidable, a pure hardware switch is ideal to keep it simple).
Also -
What does changing the SIDE PBI ID achieve?
Why would you care about joysticks 3 & 4 being off or not?
sorry if this is covered somewhere, but ive searched endlessly and i dont think its been covered as yet, where the Ultimate 1mb has more Q&A.
Rich